What Homeowners Describe
We hear the pump start again within a minute or two of shutting off, and the pit refills while we watch. The discharge line may feel warm, and water can be trickling back down it. Sometimes the float sits too high, or the pump sits in grit that keeps the switch from dropping cleanly. A check valve that has failed lets every gallon drain straight back into the pit. We also check the pit lid.
What Is Usually Happening
A pump should run in bursts and rest between them. Constant cycling means more water is arriving than the pit can clear, or the water already moved is returning. A stuck float, a bad check valve, a clogged intake screen or a discharge line that empties too close to the foundation all cause it. A rising water table does too.
What It Does to the House
Short cycles wear out the motor and switch long before their time. When the pump finally quits during a storm, the pit overflows and the basement takes water. Water returning through the line also soaks the soil by the wall. The pump then runs longer on every cycle.
What It Means for the People Inside
An open, damp pit adds humidity to the basement and can support mold growth nearby. A sump pit is also a common path for soil gas, so a loose or missing lid may let radon into the home. A professional radon test is the only way to know.
The Next Step That Saves Money
Have us watch one full cycle and check the float, intake and discharge route. Before the visit, write down how often the pump runs and whether it is worse after rain. Have any pump paperwork and the discharge location ready.
EcoSpect works across the Finger Lakes and Central New York, including Cayuga County, Chemung County, Cortland County, Jefferson County, Monroe County. If you are outside these counties, call (855) DRY-BSMT and we will confirm coverage.
What People Search Next
- sump pump runs every few minutes
- sump pump running constantly after rain
- sump pump cycles on and off quickly
- water draining back into sump pit
- sump pump won't stop running
- sump pump float stuck
- sump pump check valve not holding