What Homeowners Describe

The pit is full and the pump is silent. The float hangs loose or is stuck against the side of the pit. The outlet has no power, or the circuit has tripped. The cord shows damage, and the impeller does not turn when we reach it. In some cases the pump hums but does not move water. Water has risen above the inlet, and the floor around the pit is wet.

What Is Usually Happening

A sump pump starts when the float rises, closes a switch, and sends power to the motor. Any break in that chain stops the pump. A float can stick, a switch can fail, a motor can seize, or the check valve can jam. A pump that has not run for months can stick at the moment it is needed.

What It Does to the House

Without the pump, water from the drain tile has nowhere to go and rises into the basement. Flooring and stored goods take on water, and the wall stays wet. If it fails during a storm, the damage is worse than a normal leak. A pump that runs dry can also burn out.

What It Means for the People Inside

Standing water raises humidity and can support mold in flooring and drywall. Water near the pump and outlet is an electrical shock risk. A wet floor is also a slip hazard, especially on stairs. Mold can grow quickly.

The Next Step That Saves Money

Test the pump by pouring a bucket of water into the pit and watching the float. If it does not start, check power and the float before replacing the pump. Check the check valve too.

EcoSpect works across the Finger Lakes and Central New York, including Yates County, Cayuga County, Chemung County, Cortland County, Jefferson County. If you are outside these counties, call (855) DRY-BSMT and we will confirm coverage.

What People Search Next

  • sump pump not turning on
  • sump pump float stuck
  • sump pump no power
  • sump pump repair
  • sump pump humming not pumping
  • sump pump test
  • basement sump failure