What Homeowners Describe
We see ridges, lumps, and shallow dips across the surface where the material was sprayed. Some areas stand proud and others sit thin. A straight edge shows waves rather than a flat plane. The surface may be sound but hard to coat. After rain, the high spots dry first and the low spots stay dark. The surface looks uneven from across the room and worse up close. Low spots hold a thin film of water.
What Is Usually Happening
Shotcrete is placed by spraying, so the finish depends on the nozzle work and the trim that follows. An uneven surface collects water in the dips and dries unevenly. Coatings fail first at the thin spots. The structure can be fine while the face is not ready for the finish it is meant to carry.
What It Does to the House
Water sitting in low spots works at the surface and any coating on it. Thin areas weather faster, and the wall becomes harder to seal as the unevenness grows. Cosmetic patching tends to show through. Water sits in the dips and works at the surface below.
What It Means for the People Inside
Low spots that hold water can keep a wall damp, and damp surfaces may support mold where the space is enclosed. Uneven thickness can also leave weak spots that damage more easily. Damp spots can hold water against the wall.
The Next Step That Saves Money
Have the surface checked with a straight edge and the low and thin areas filled and finished so a coating can bond evenly. A straight edge and a hammer tap show where the surface is thin.
EcoSpect works across the Finger Lakes and Central New York, including Chemung County, Cortland County, Jefferson County, Monroe County, Onondaga County. If you are outside these counties, call (855) DRY-BSMT and we will confirm coverage.
What People Search Next
- shotcrete uneven finish
- shotcrete lumps
- sprayed concrete finish
- shotcrete thin spots
- shotcrete leveling
- shotcrete coating
- shotcrete wall