What Homeowners Describe
We see a tapered gap along one side as the door comes down. The track is out of plumb, and the door binds partway. The floor slab under the door has settled at one end, and the header above shows a crack. The opener strains at the end of travel, and the bottom seal does not touch the floor evenly. The door panels look level at the top but the bottom sits uneven.
What Is Usually Happening
A garage door runs on tracks that are set to the opening. When the slab settles or the wall moves, the opening goes out of square and the tracks follow. The door then cannot close evenly. A gap along one side lets water, wind, and pests in, and the opener works against the misalignment. The springs strain.
What It Does to the House
The gap lets rain and snow in at the corner, and the floor stays wet. The opener and springs wear faster from the strain. A door that comes off track can fall. The slab movement that caused the problem usually continues. The seal may fail.
What It Means for the People Inside
A garage door that binds can reverse or drop without warning, which is a serious injury risk. Exhaust fumes can enter the house through a gap at the bottom. Water at the threshold can freeze and create a slip hazard.
The Next Step That Saves Money
Measure the opening for square and check the slab at the threshold before adjusting the tracks. The door can be aligned, but it will move again if the floor is settling. Note both sides of the gap.
EcoSpect works across the Finger Lakes and Central New York, including Ontario County, Schuyler County, Seneca County, Steuben County, Tompkins County. If you are outside these counties, call (855) DRY-BSMT and we will confirm coverage.
What People Search Next
- garage door not closing square
- garage door gap on one side
- garage door out of alignment
- garage slab settled
- garage door track out of plumb
- garage door binds
- garage floor uneven at door